Bhutan acdc power module potting requirements(1)

The potting of the acdc power module is very important. This process not only involves the protection of the power module potting acdc power module (waterproof, moisture-proof, dust-proof, anti-corrosion, etc.), but also involves the protection of the power module. thermal design.

Commonly used power module potting materials are divided into three categories: epoxy resin, polyurethane and silicone rubber

The high-voltage DC power supply for electrostatic precipitator has been developed in China. The commercial power is rectified into DC, and the full-bridge zero-current switch series resonant inverter circuit is used to invert the DC voltage to a high-frequency voltage, which is then boosted by a high-frequency transformer, and finally rectified. for DC high voltage. Under the condition of resistive load, the output DC voltage reaches 55kV, the current reaches 15mA, and the operating frequency is 25.6kHz.

Epoxies cannot be used for stress-sensitive and module sealing due to their hardness and are basically eliminated by module power supplies. However, due to its low cost, this epoxy is still used in cost-sensitive micropower supplies. Some domestic bad Marine boost voltage power supply manufacturers also use this epoxy resin acdc Marine boost voltage power supply module. However, due to stress problems, the failure rate of this Marine boost voltage power supply is very high, and buyers are miserable.